Welcome! Log In Create A New Profile


Slic3r help

Posted by danlad1631 
Slic3r help
August 17, 2013 01:54PM

I don't seem to be able to get slic3r to infill small areas, see picture attached. Sorry about the quality.

What is the setting I need to change to correct this?

open | download - no infill.jpg (354.7 KB)
Re: Slic3r help
August 17, 2013 02:00PM
change the minimum numbers of perimeters, to be 3 or 4, and also decrease nozzle size, if 0.5 say 0.48 in settings. also retraction settings may need to be modified as well

post your slicer config settings. someone will help you get it figured out.
Re: Slic3r help
August 17, 2013 03:22PM
Also, what version of Slic3r are you using?

Help improve the RepRap wiki!
Just click "Edit" in the top-right corner of the page and start typing.
Anyone can edit the wiki!
Sorry, only registered users may post in this forum.

Click here to login