Hi,

I don't seem to be able to get slic3r to infill small areas, see picture attached. Sorry about the quality.

What is the setting I need to change to correct this?

Thanks

change the minimum numbers of perimeters, to be 3 or 4, and also decrease nozzle size, if 0.5 say 0.48 in settings. also retraction settings may need to be modified as well



post your slicer config settings. someone will help you get it figured out.

Also, what version of Slic3r are you using?

---

Help improve the RepRap wiki! Just click "Edit" in the top-right corner of the page and start typing. Anyone can edit the wiki!