Welcome! Log In Create A New Profile


Some help with ramps

Posted by adominguez 
Some help with ramps
December 02, 2013 03:06AM

I´m thinking in electronic to do my new printer. I have experience with megatroncis but now I want change to ramps. But my problem is that I like to use dual extruder with two thermocouple. Me doubt is where I connect the second thermocouple board in ramps. Other problem is the use of fan, can I use fan for piece with dual extruder and hot bed?

Thanks for help
Re: Some help with ramps
December 02, 2013 07:02AM
you can start reading about ramps from here:

Note: RAMPS doesn't read thermocouples. you must use a thermistor !!!

Edited 1 time(s). Last edit at 12/02/2013 07:03AM by Osama.
Re: Some help with ramps
December 02, 2013 07:18AM
I read wiki page. I can use with external board for thermocouple. I know where I have to connect one of this board, but i don´t konw where i have to connect the second
Re: Some help with ramps
December 03, 2013 01:44PM

Second Extruder Sensor gets plugged into T2

It's all right there in the wiring information on the RAMPS 1.4 wiki


Edited 2 time(s). Last edit at 12/03/2013 01:45PM by ShadowRam.
Sorry, only registered users may post in this forum.

Click here to login