Welcome! Log In Create A New Profile

Switching between ABS, Nylon 618, and T-Glase

BlaiddDrwg

Switching between ABS, Nylon 618, and T-Glase
February 14, 2014 06:33PM

Registered: 12 years ago
Posts: 98

So I've been printing with 3mm ABS, I recently received Taulman's 618 nylon and some T-Glase. I was wondering if anyone had experience or tips/tricks for switching between these filaments? My Prusa has a Magma hot end.

Thanks!

Reply Quote

strantor

Re: Switching between ABS, Nylon 618, and T-Glase
February 14, 2014 07:06PM

Registered: 12 years ago
Posts: 38

I just get it up to 240c, pull it out, put the new stuff in, and purge a hundred mm.