Hi,
This is more of a dilemma that I have in choosing a printer design.
I was wondering if prints are more accurate when the Bed is on the Z-axis (like the Ultimaker/2, replicator/2X) than when its on the Y-axis (Prusa i2/i3)
Then way I see it is, the part printing gets jerked around alot more when its on the y-axis.
the Z-axis one suffers only minimal drops /layer heights in movement.
Of coarse, i'm talking about higher speed prints.. lets say 80mm/s - 100mm/s.
I see that the Y-axis printers are very popular so that is why i'm asking.
anyone have a tough on this ?
Thanks :-)
J-F
Thanks :-)