Axis Calibration

Hello guys I am working on a Rostock 3D-printer with my partner. We have already built the printer but now we do have some problems with the firmware. We are using Arduino 0023
and as Firmware we downloaded this one [github.com]. As Pronterface we use Reptier Host an after uploading when i try to manually move the axis just 1 mm x and y are moving until we disconnect the power and the z axis is not really moving at all. I really hope someone can help me

Armin

Are you sure you have enabled "delta printer" in the configuration?

I changed the configuration files but i dont exactly know if i enabled it . It would be very nice of you if you could share your configuration.h file with me if you did build a rostock too.

start with copying the files from example_configurations/delta into the root directory of marlin replacing the two configuration files there.