Run Self-Sourced Ultimaker 2 with RAMPS/Marlin? July 07, 2014 02:11AM |
Registered: 9 years ago Posts: 26 |
Re: Run Self-Sourced Ultimaker 2 with RAMPS/Marlin? July 07, 2014 04:32AM |
Registered: 13 years ago Posts: 7,616 |
Quote
Kyle R
If I built a complete Ultimaker 2 (XY gantry, Z stage) is it possible for me to control it with a RAMPS 1.4 board instead of the Mainboard 2.1.1 from Ultimaker? Is it possible to control with Ultimaker 2 with the Ultimaker Original Arduino shield? I'm assuming the answer to both of these questions is yes, so how would the performance be affected?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Run Self-Sourced Ultimaker 2 with RAMPS/Marlin? July 08, 2014 02:23AM |
Registered: 9 years ago Posts: 26 |