Create your own G code? August 16, 2014 04:20PM |
Registered: 9 years ago Posts: 26 |
Re: Create your own G code? August 16, 2014 09:56PM |
Registered: 13 years ago Posts: 1,797 |
Re: Create your own G code? August 17, 2014 05:55AM |
Registered: 13 years ago Posts: 7,616 |
Quote
Kyle R
How would I stop the G code generator from producing the filiment extruding g-code while including my own command?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Create your own G code? August 18, 2014 03:41AM |
Registered: 9 years ago Posts: 26 |
Re: Create your own G code? August 18, 2014 12:51PM |
Registered: 10 years ago Posts: 553 |
Quote
Kyle R
Thank you both for your thorough replies, I'm now really starting to get a strong feeling for how G code is structured. My next conceptual challenge is how to get the slicer to actually include those commands within the code itself. I have been able to manually enter g code commands and get my valves to open and close with my modified firmware, but am having trouble finding how to get them included in the g code program automatically.
Thanks again!
Re: Create your own G code? August 18, 2014 03:12PM |
Registered: 9 years ago Posts: 26 |
Re: Create your own G code? August 18, 2014 03:30PM |
Registered: 11 years ago Posts: 172 |