Question about normally open vs normally closed endstops. November 03, 2014 11:59PM |
Registered: 9 years ago Posts: 38 |
Re: Question about normally open vs normally closed endstops. November 04, 2014 12:27AM |
Registered: 11 years ago Posts: 1,592 |
Re: Question about normally open vs normally closed endstops. November 04, 2014 09:40AM |
Registered: 10 years ago Posts: 869 |
Depending on the particulars of your electronics, the current is extremely small. A MEGA 2560 board for instance has pull-up resistors of between 20k and 50k ohms, so .25-.1 milliamps per end stop. It's less than a rounding error in the scheme of everything else with your printer.Quote
scubaguy
But isn't that wasting electricity, even if only a tiny trickle, having it constantly flowing through the switch.
Re: Question about normally open vs normally closed endstops. November 05, 2014 05:10PM |
Registered: 9 years ago Posts: 44 |
Re: Question about normally open vs normally closed endstops. November 13, 2014 02:49PM |
Registered: 11 years ago Posts: 45 |
Re: Question about normally open vs normally closed endstops. November 14, 2014 03:19PM |
Registered: 9 years ago Posts: 44 |