This is still happening in the current host software (July 2010). In the previously posted files the first error is at layer 3.
The gcode does not do the shield as per normal
Quote
;#!LAYER: 3/50
G4 P6 ;delay
M107 ;cooler off
G4 P20 ;delay
G1 F5.0; feed for start of next move
G1 Z0.45 F30.4 ;z move
G1 Z0.6 F5.0 ;z move
G1 F1500.0; feed for start of next move
G1 X1.0 Y0.5 F2209.5 ;horizontal move
G1 X2.0 Y0.9 F1500.0 ;horizontal move
G1 F8000.0; feed for start of next move
G1 E3.3; extruder dwell
G1 F1500.0; feed for start of next move
The start of layer should look like the following
Quote
;#!LAYER: 2/50
G4 P14 ;delay
M107 ;cooler off
G4 P20 ;delay
G1 F5.0; feed for start of next move
G1 Z0.15 F30.4 ;z move
G1 Z0.3 F5.0 ;z move
G1 F1500.0; feed for start of next move
G1 X-1.5 Y-1.5 F2709.5 ;horizontal move
G1 X-3.0 Y-3.0 F1500.0 ;horizontal move
G1 F8000.0; feed for start of next move
G1 E3.3; extruder dwell
G1 F1500.0; feed for start of next move
G1 F3000.0; feed for start of next move
G1 E5.0; extruder dwell
G1 F1500.0; feed for start of next move
G1 X-3.6 Y-0.2 E7.9 F3000.0 ;horizontal move
G1 X-4.3 Y3.6 E11.7 ;horizontal move
G1 X-5.0 Y7.0 E15.2 F764.6 ;horizontal move
G1 Y3.5 E18.7 F3000.0 ;horizontal move
Does anyone else have this problem or any idea why the reprap host software would generate gcode like this?
Test GCode
Test STL
The gcode produced by the 20091106 release of the reprap host does not contain these errors.
The 20100806 release still makes these errors.
Edited 2 time(s). Last edit at 08/12/2010 05:18PM by brokentoaster.