Welcome! Log In Create A New Profile

Print hotter for smaller nozzles?

Posted by UkIan

UkIan

Print hotter for smaller nozzles?
January 17, 2015 12:38PM

Registered: 8 years ago
Posts: 376

Trying a.0.25mm nozzle, prints are nice, but having a few layer bonding issues. Bit weak. Any guidance on tiny nozzles?
Thanks
Ian

Reply Quote

Srek

Re: Print hotter for smaller nozzles?
January 17, 2015 06:56PM

Registered: 11 years ago
Posts: 2,470

For me the temperature doesn't make much of a difference. You should make sure that the amount of material is correct. If you extrude a bit less than is needed you won't notice it much with a big nozzle, but a lot more with a small one. We are not talking about huge differences, but enough to make tlayers stick or not.

Edited 1 time(s). Last edit at 01/17/2015 06:57PM by Srek.

[www.bonkers.de]
[merlin-hotend.de]
[www.hackerspace-ffm.de]

Reply Quote

UkIan

Re: Print hotter for smaller nozzles?
January 18, 2015 03:26AM

Registered: 8 years ago
Posts: 376

Interesting, I'll try extruding a bit more and see where that gets me smiling smiley

Reply Quote

Ralph.Hilton

Re: Print hotter for smaller nozzles?
January 18, 2015 07:48AM

Registered: 9 years ago
Posts: 439

I find that temperature does make a difference and that higher temperatures give better adhesion printing with PLA and PETG.

Reply Quote

MindRealm

Re: Print hotter for smaller nozzles?
January 18, 2015 01:21PM

Registered: 8 years ago
Posts: 329

Also, realize that the thinner the extruded diameter, the quicker the material cools. Thus, environmental temperature, drafts and fan usage becomes a concern. I have considered the use of a heat lamp when printing with smaller nozzles, though I haven't done it yet.

-David

Find me online at:
Thingiverse
Instructables.com
LinkedIn
Facebook

Check out my FolgerTech Prusa i3 (plexi) at MindRealm.net