I'm having a weird issue I've never seen before with a RAMPS board. When I power my hot end with the manual control in repetier it powers my x and y steppers. I have the wires pretty isolated from the hot end wire. When I go to make carriage movements with the hot end on, the steps are jerky and definitely different when the hot end's off. With the hotend off, the x and y axes work fine in my Corexy setup. I've also found on my smart controller when I go to heat the extruder the controller screen blinks and goes back to home screen. It works with the heated bed though. Has anyone experienced this or have any info? Thanks!
Edited 1 time(s). Last edit at 02/07/2015 07:15PM by runninfarmer.