We are attempting to upload the reprap firmware to the extruder controller using the adruino program. However, we keep getting the same error.
avrdude: stk500_getsync() : not in sync: resp=0x00
avrdude: stk500_disable() : expect=0x14, resp=0x51
We walked through some of the recommended troubleshooting measures from the
arduino's website, but we are still having the same issue.
We have it set to compile code for the diecimila.
If it is important, we are using the techzone remix boards.
Sorry to trouble you all, but neither of us know the proper way to do this.