Help!!!!
Posted by Jihoon_Lim
|
Help!!!! March 24, 2015 08:00AM |
Hey guys,
I'm engineeing student in Korea and I am studying about 3D printer.
I am going to look into source code and make prototype of slicer engine.
Does anyone know what's the easiest and best reference for primitive slice engine?
I need a help from you guys
Thanks
I'm engineeing student in Korea and I am studying about 3D printer.
I am going to look into source code and make prototype of slicer engine.
Does anyone know what's the easiest and best reference for primitive slice engine?
I need a help from you guys
Thanks
|
Re: Help!!!! March 24, 2015 09:20AM |
Hey, I've been working with a GCODE generator for Inkscape, it is called Laserengraver.
Find more about it here:
[www.keerbot.com]
I've been changing the generator so it allows me to cut with a laser and adds in on/off pulses on line starts and ends etc. The whole thing is, there is a special gcode path generator built in, but it's all in python I believe so you might be able to dig into it's intestines and find out what does what
Hope I'm helping you further. Mind you, this is not for 3D-printing as it doesn't involve height calculations.
http://www.marinusdebeer.nl/
Find more about it here:
[www.keerbot.com]
I've been changing the generator so it allows me to cut with a laser and adds in on/off pulses on line starts and ends etc. The whole thing is, there is a special gcode path generator built in, but it's all in python I believe so you might be able to dig into it's intestines and find out what does what
Hope I'm helping you further. Mind you, this is not for 3D-printing as it doesn't involve height calculations.
http://www.marinusdebeer.nl/
Sorry, only registered users may post in this forum.