I have a homemade printer using a printrboard. The new power supply is a 36A server power supply (my stock 10A struggled with the 100w HPB ) and I have the supply hardwired on, similar to an ATX PSU's green wire. Can I somehow power the printerboard's logic circuitry over USB and have the marlin firmware configured to enable the power supply when needed, and otherwise switch it off? I would really like this noisy beast to be off when it isnt being used. Thanks!
Edited 2 time(s). Last edit at 04/05/2015 12:13PM by iamdarkyoshi.
