Welcome! Log In Create A New Profile

Problem with my printer negavite axe

thedead05

Problem with my printer negavite axe
April 15, 2015 12:20PM

Registered: 9 years ago
Posts: 13

hi, all positive deplacement work +X,+Y and +Z but don't work on negative -X,-Y,-Z i have sanguinololu using pronterface or repetier-host same think happen.
Prusa i3 buy from Geeetech on ebay.
you can help me?
if you wanna screenshot or picture let me know.
thank

Reply Quote

ggherbaz

Re: Problem with my printer negavite axe
April 15, 2015 02:00PM

Registered: 10 years ago
Posts: 1,401

Check your endstops with M119 in pronterface, most likely are triggered.

Reply Quote

thedead05

Re: Problem with my printer negavite axe
April 15, 2015 02:32PM

Registered: 9 years ago
Posts: 13

What is M119 and how i do it, do you have screenshot please i don't understant what you wan i do...

Reply Quote

ggherbaz

Re: Problem with my printer negavite axe
April 15, 2015 08:04PM

Registered: 10 years ago
Posts: 1,401

Just write M119 in the command line in pronterface and it will display the status of the endstops.

If any shown triggered without actually been triggered, change it's logic in Marlin.

[t00tiereprap.files.wordpress.com]

Edited 1 time(s). Last edit at 04/15/2015 08:06PM by ggherbaz.