Hot End Not Heating Up

I may have put this topic in the wrong place and I apologize but I am having hotend issues. When I go to heat the hotend up in preparation for printing the temperature remains the same. Reading the output voltage on the Ramps 1.4 is showing 0 volts when the hotend is turned on. All motor, fan, and heated bed are working fine. I am really looking forward to my first print, and this is my last issue... hopefully. I am using a Ramps 1.4 in the EFB cofiguration. Thank.Thank you in advance.

1. Is the hot end LED on?
2. Measure between the hot end + terminal and the - terminal of your power supply. What's your voltage there?
3. When the hot end should be on, what's the voltage between power supply - and the gate pin on the mosfet? The gate pin is the pin closest to the stepper drivers or polyfuse depending on which one you're measuring.

I'll have to check when I get done with school Today.

Ok, when I tilted the MOSFET closest to the extruder motor driver the led came on and the power supply came on and began drawing power. It quickly began heating up. I guess I will order new MOSFETS just in case. For your questions.

Before tilt
1) No
2)12v
3)5v near outside, 0 near fuses

After tilt
1)Yes
2)12 v
3)My hotend MOSFET pins detached

Elaborating on part 3, the pins snapped off of the board. Where should I purchase a new MOSFET?