Welcome! Log In Create A New Profile

Advanced

Heatbed Not more Than 95°C

Posted by Fuselium 
Heatbed Not more Than 95°C
May 08, 2015 09:54AM
Hi guys,

I just built my own 3D Printer.
I tried to Print Abs on 120°C But my heated bed just doesnt get above 95°C. What can i Do?

Edited 1 time(s). Last edit at 05/08/2015 09:55AM by Fuselium.
Re: Heatbed Not more Than 95°C
May 08, 2015 10:21AM



Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse
Re: Heatbed Not more Than 95°C
May 08, 2015 11:03AM
You dont need the bed at 120c.
I have been printing my ABS at 105c and sometimes 110c.
Re: Heatbed Not more Than 95°C
May 08, 2015 11:05AM
Ok But i dont reach 110°C only 95
Re: Heatbed Not more Than 95°C
May 08, 2015 11:24AM
Have you already put a piece of cardboard on top while heating up, and how is the isolation beneath the bed ?

chri


[chrisu02.wordpress.com] Quadmax Intel Delid Tools
Re: Heatbed Not more Than 95°C
May 08, 2015 11:27AM
Yes i have a piece of cardboard on Top an this helped But underneeth there is nthing. What should i use
Re: Heatbed Not more Than 95°C
May 08, 2015 01:42PM
ebay search glass mat
Re: Heatbed Not more Than 95°C
May 08, 2015 03:12PM
A piece of cardboard, insulation, cork, etc under it can also provide additional insulation value. A bed with lower resistance will also increase the power, allowing for higher temperatures and/or faster heating. My bed is .8 ohms and reaches 110 degrees in about 2 minutes with a 3/16" glass sheet on top, but also results in it drawing 15 amps and producing 180 watts of heat.
Re: Heatbed Not more Than 95°C
May 09, 2015 04:32AM
What kind of board and PSU are you using?
Re: Heatbed Not more Than 95°C
May 10, 2015 06:45AM
I finally soved it by putting a piece of cardboard beneeth my heatbed!! No Problem printing ABS now

Thank You
Sorry, only registered users may post in this forum.

Click here to login