Manual Homing Switch Locations ?
June 02, 2015 02:40PM
Hi,
Please can tell me what the " Manual Homing Switch locations " setting is for in Marlin. Building the Mendel90 , end stops are at right side for x axis , Z is at the top and the Y axis is in the front. All set as Max .
I notice the setting on x,y and z are 0 .
What I don't understand is that my end stops are at Max and that where my printer homes to the Max position. So Should the Z Manual Homing switch location be 200.

Thanks
Sorry, only registered users may post in this forum.

Click here to login