Welcome! Log In Create A New Profile


E3D lite

Posted by ntar827 
E3D lite
June 08, 2015 05:37PM
Understanding the temperature limits, is the E3D V6 lite as good a hot end as the much more expensive E3D V6?

Re: E3D lite
June 08, 2015 06:55PM
It has the ptfe liner down into the hotzone therefore limiting you temps up to 250C. I bought one for a secondary printer that I want to sell of and I assume it will be much better than any cheap chinese stuff in the same price category.
Re: E3D lite
June 08, 2015 09:52PM
It is a very good hotend for the price. If you don't plan on going above 240c, you will be pleased.
Re: E3D lite
June 10, 2015 03:20PM

How long have you been using the E3D Lite?
Re: E3D lite
June 10, 2015 10:30PM
I only used it for a few days. It was the hotend choice for a custom printer I built and sold. I use the e3d v6 on my printer, but trust that e3d is going to put out quality. It did not skip a beat during calibartion and testing. If I had anything bad to say is the ptfe tube needs a good straight cut to meet the tip, other then that a big thumbs up.
Sorry, only registered users may post in this forum.

Click here to login