Welcome! Log In Create A New Profile


Execute Gcode immediately in pronterface?

Posted by jessicabrenner 
Execute Gcode immediately in pronterface?
July 06, 2015 11:40PM
I notice that when I enter gcode into pronterface, it takes some time for the code to actually execute if I'm in the middle of a print. Is there a way to make it execute it immediately? If I have to edit the marlin firmware, I'm ok with that, but I'm hoping there's a simpler way. Maybe I can just decrease the # of lines that get stored in some buffer somehow. Any ideas?
Sorry, only registered users may post in this forum.

Click here to login