Welcome! Log In Create A New Profile


nozzle wipe before printing ?

Posted by Nikki81 
nozzle wipe before printing ?
July 19, 2015 04:43AM
I want to start using octopi with my p3steel is it possible to have the printer wipe the nozzle before printing to get rid of the warmup ooze ?

Thanks Nikki
Re: nozzle wipe before printing ?
July 26, 2015 05:29PM
Yes... there are a couple different ways depending on your board... One is the firmware/config going through motions of "go here, do this on tool select" another is in the slicer ... either way I think its about the same... move to the wipe area, extrude, move over the wiper, extrude, move over the wiper... then print
Sorry, only registered users may post in this forum.

Click here to login