Hello,everyone,I come fron China,and my english is turly bad,Now I have a problem.
You see,I want to control my prusa i3 by bluetoothin my phone?But if I add JY-MVC (which is the cheap module that can connect melzi to bluetooth)to melzi and control by my phone,should I put my phone close to my i3 while printing?
Of course I will write a program to connect my phone to melzi.
I think If i convert the stl to Gcode and send all the message to the melzi at once,mybe i can leave and let it pringing itself.Hoever,if I leave a while and after some minutes i come back then I want to pause it?how can i get connected again?
I think maybe the best way to control the i3 is through wifi not Bluetooth?
I am so sorry that I am not familiar with arduino programing,so maybe my question is really simple?