Welcome! Log In Create A New Profile

Advanced

Can't connect to hosting software

Posted by SkeptikRC 
Forum List Message List New Topic
SkeptikRC
Can't connect to hosting software
September 05, 2015 08:59AM
Hello, I have a prusa I3B and have been trying to connect it to my macbook pro. I've tried pronterface, repetierhost and mattercontrol with no luck. The best I got was a supposed connection on repetier but no control. What am I doing wrong? Sorry if I missed any information I'm new to this.

Thank you.
Reply Quote
AlexY
Re: Can't connect to hosting software
September 05, 2015 01:45PM
What electronics are you using?
Reply Quote
SkeptikRC
Re: Can't connect to hosting software
September 05, 2015 06:17PM
Quote
AlexY
What electronics are you using?
Hi Alex, I am using the Sanguinololu control board.
Reply Quote
AlexY
Re: Can't connect to hosting software
September 09, 2015 12:18AM
I use a ramps board myself, so I can't really help with board-specific issues.

Did you try using a different computer or a different cable?

Also, try changing the baud rate setting in your host software.

Edited 1 time(s). Last edit at 09/09/2015 12:19AM by AlexY.
Reply Quote
Dust
Re: Can't connect to hosting software
November 26, 2020 08:08PM
do you have ftdi serial drivers installed?

[www.ftdichip.com]
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login