Welcome! Log In Create A New Profile

y axis

Posted by Kevinrh

Kevinrh

y axis
September 22, 2015 01:36AM

Registered: 9 years ago
Posts: 16

When I start printing, the print gets to about 8 layers. Then the y axis crashes to the back and X to the left. This happens when I use Cura. When I use Slic3r then it doesn't do that. The Cura worked fine previously. What could cause this.

Reply Quote

J-Max

Re: y axis
September 22, 2015 03:14AM

Registered: 10 years ago
Posts: 722

Hi,

Maybe you need to uninstall Cura
and do a new installation.

++JM

Reply Quote

dc42

Re: y axis
September 22, 2015 04:24AM

Registered: 11 years ago
Posts: 14,686

What printer electronics and firmware are you using?

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

Kevinrh

Re: y axis
September 22, 2015 08:33AM

Registered: 9 years ago
Posts: 16

I am using ramps electronics and Marlin.

Reply Quote

Newer Topic Older Topic

Print View RSS

Sorry, only registered users may post in this forum.

Click here to login