I think I'm just thick here. I've looked and looked for this answer but I can't figure it out.

Once I generate the gcode from Skeinforge, how do I send it to the printer? With the RepRap host there is a button to click to send the gcode to the printer but I've looked at the skeinforge documentation and everything seem to deal with the setting for generating the gcode. I'm just confused.

I know I've probably just overlooked it some place but I have looked for several hours.

You generate it with SF and then send it with the Reprap host using the send g-code to printer button you mentioned.

---

[www.hydraraptor.blogspot.com]

Thank you so much. I had thought of that but wasn't sure. I didn't know if the send function was specific to the application or not.

I'm just learning here so I appreciate it.