Welcome! Log In Create A New Profile

wifi conecting?

Posted by munchit1

munchit1

wifi conecting?
January 06, 2016 07:46AM

Registered: 11 years ago
Posts: 159

hi all, sorry if its the rong section but..

is it yet posable to just plug a wifi int a 3d printer?

(i dont mean buy a read made with the added feature though..literally, buy a wifi and conect it up?)

Reply Quote

dc42

Re: wifi conecting?
January 06, 2016 10:04AM

Registered: 11 years ago
Posts: 14,688

If you have Duet electronics, then yes. You connect the Ethernet port to a TPLink WR710N or similar WiFi to Ethernet bridge.

There is also a thread on the Developers section on how to connect RADDS or Duet electronics to WiFi using a low-cost ESP8266 module.

Edited 1 time(s). Last edit at 01/06/2016 04:12PM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

munchit1

Re: wifi conecting?
January 06, 2016 02:27PM

Registered: 11 years ago
Posts: 159

thank you dc42 i'll have a ganders there.

Reply Quote

Dust

Re: wifi conecting?
January 06, 2016 07:18PM

Admin
Registered: 14 years ago
Posts: 7,282

Most use a raspberry pi running octoprint as a printer server. This can be wifi or cabled, your choice... (printer is still connected to usb)

Reply Quote

munchit1

Re: wifi conecting?
January 07, 2016 06:37AM

Registered: 11 years ago
Posts: 159

the idia was to isolate the printer to save killing any ports.

Reply Quote

dc42

Re: wifi conecting?
January 07, 2016 07:06AM

Registered: 11 years ago
Posts: 14,688

I presume you are referring to the risk of killing USB ports due to transients on the ground loop you get when you connect a printer and a PC via USB. Wired ethernet is another good solution, because it provides galvanic isolation, unlike USB.

Edited 1 time(s). Last edit at 01/07/2016 07:59AM by dc42.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

munchit1

Re: wifi conecting?
January 07, 2016 07:51AM

Registered: 11 years ago
Posts: 159

Quote
dc42
I presume you are referring to the risk of killing USB ports due to transients on the ground loop[ you get when you connect a printer and a PC via USB. Wired ethernet is another good solution, because it provides galvanic isolation, unlike USB.