I just built a new Prusa clone which came with installed firmware and noticed there is a temperature readout jump from 82c to 95c.
I also recently saw a thread somewhere with a similar issue but that person provided their config.H file.
In their file one of the tables had the pairs out of sequence.
I suspect this is my problem so I am raising this as there seems to be some incorrect config.h settings being used and this may grow as it seems to be at a source used by some suppliers.
Does anyone know of a way of viewing the values in the firmware. The tables are not being reported by an EEPROM dump.
Sorry if this is the wrong place
