Meanwell supplies have a good reputation. Here's a 15V 13.4A (200W) supply for the same price as the low quality cheapies from ebay ($25):

[www.goldmine-elec-products.com]

Data sheet here:

[www.advice.co.il]

Mouser sells the same supply for $63.

---

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Thanks DD but is that enough to run everything or just HB or mainboard? On an I3.

Since it can't be adjusted down to 12V, and 15V fans/heater cartridges are rare/expensive, am I right to assume this should be used just for the motors, and a different supply for heaters/fans (or with a buck converter)? Or do the heaters not really care about a bit higher/lower voltage since they're basically a wire resistor? Would the current they draw be a bit too much if used at 15V?

Yeah, I realized that after I posted and couldn't figure out how to delete the post. Nevermind...

---

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]