Get this liner out.

I must have cooked the liner in my e3d lite6. I heated up the cool block and removed a piece of pla that was stuck in there but I can't get the rest of the ptfe tube out of there. I have been trying with a drill bit but I can't get the outer layer out it's stuck to the cool block.

Anyone know how to get it out?

---

Newbie with Folgertech 2020 i3.

I got it out by using the largest drill bit that would fit in there I suppose I scored the inside but I wouldn't think it would matter since the filament is going though the liner anyway. Is it supposed to fit so tight at the bottom of the cool block? I don't remember it being that way when I put it together the first time. Oh well the filament still goes through there freely.

---

Newbie with Folgertech 2020 i3.