2 Fans to be independent March 08, 2016 06:21PM |
Registered: 8 years ago Posts: 318 |
Re: 2 Fans to be independent March 08, 2016 06:25PM |
Registered: 9 years ago Posts: 978 |
Re: 2 Fans to be independent March 09, 2016 10:21PM |
Registered: 8 years ago Posts: 318 |
Re: 2 Fans to be independent March 10, 2016 12:14AM |
Registered: 9 years ago Posts: 182 |
Re: 2 Fans to be independent March 10, 2016 08:14AM |
Registered: 9 years ago Posts: 1,873 |
Quote
gmckee
To add a second hotend and continue to use a software fan you would need an custom setup.
Re: 2 Fans to be independent March 11, 2016 09:28AM |
Registered: 8 years ago Posts: 3,525 |
Re: 2 Fans to be independent March 13, 2016 05:56AM |
Registered: 8 years ago Posts: 2 |
Re: 2 Fans to be independent March 13, 2016 07:48AM |
Registered: 9 years ago Posts: 1,873 |
Quote
Peteorama
Hey guys, I have a similar problem. My E3D V6 has a fan that always needs to be on with a push fit connector on the end and the kit I have also comes with a fan that needs to be directed onto the ramps board for cooling.
Both have the white push fit connectors. I'm very new to all this and inexperienced. are there any places on the RAMPS 1.4 board that these can be easily connected to?
The guy who supplied me the kit suggests wiring both fans to D9 in series and keep the fan option set to on, but I'd really rather keep D9 free for a cooling fan for prints in the future if possible.
If there are pins i can just push fit to that will keep these fans always on could someone please attach a diagram to help me understand where they can go.
Or if connecting to D9 is the better option for now, do I simply remove the connectror ends and put both cables into the respective D9 outs and screw them down?
Sorry for being a needy newb
Re: 2 Fans to be independent March 13, 2016 07:54AM |
Registered: 8 years ago Posts: 3,525 |
Re: 2 Fans to be independent March 13, 2016 12:06PM |
Registered: 8 years ago Posts: 2 |
Re: 2 Fans to be independent September 27, 2016 02:43AM |
Registered: 9 years ago Posts: 223 |