Welcome! Log In Create A New Profile

I think my arduino passed away

Shachar85

I think my arduino passed away
April 29, 2016 03:37AM

Registered: 9 years ago
Posts: 63

After changing the drivers to DRV8825 on RAMPS1.4, I tried to flash Marlin again with the new configurations.
Since then, nothing seems to work. The screen becomes blue and that's it, nothing written on it.

Tried to to upload a brand new Marlin and same results. Not working.
Tried to upload Arduino's Blink example and it works.

Any ideas what's wrong?

Reply Quote

Dust

Re: I think my arduino passed away
April 29, 2016 04:17AM

Admin
Registered: 13 years ago
Posts: 7,147

Maybe you put the drv8825's in backwards?

0J4233.600.png

0J3360.600.png

Ie if your orientation is based on the position of the pot, it should be turned 180 degrees around.

eg here is an example with mixed drivers

500px-Stepper_drivers_mixed_a4988_drv8825_RAMPS_1a.jpg

Edited 1 time(s). Last edit at 04/29/2016 04:20AM by Dust.

Reply Quote

Shachar85

Re: I think my arduino passed away
April 29, 2016 04:54AM

Registered: 9 years ago
Posts: 63

I know about the orientation.
I also tried to get everything of the RAMPS excluding the screen and it still didn't work

Reply Quote

Dust

Re: I think my arduino passed away
April 29, 2016 05:18AM

Admin
Registered: 13 years ago
Posts: 7,147

please define "nothing seems to work"

can you connect to it?
can you read any temperature readings?
can you test endstops with m119?
Does the hot end heatup?
Do the stepper motors move?

or is it just a dead screen?

Reply Quote

Frans@France

Re: I think my arduino passed away
April 29, 2016 06:32AM

Registered: 10 years ago
Posts: 550

did you use the old working configuration.h or de default one?

Reply Quote

Traumflug

Re: I think my arduino passed away
April 29, 2016 08:53AM

Registered: 14 years ago
Posts: 7,616

If the Blink example works, the Arduino works. Beyond that we need more information what "doesn't work" means. Does it compile? Does it upload? What are the error messages?

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Reply Quote

Shachar85

Re: I think my arduino passed away
April 29, 2016 09:38AM

Registered: 9 years ago
Posts: 63

tried both configuration.h

nothing seems to work means the screen don't work.

how can I check anything?

Reply Quote

Frans@France

Re: I think my arduino passed away
April 29, 2016 10:00AM

Registered: 10 years ago
Posts: 550

with screen you mean LCD? Did you set the correct LCD in your configuration.h?

Reply Quote

Shachar85

Re: I think my arduino passed away
April 29, 2016 11:07AM

Registered: 9 years ago
Posts: 63

wow this is so stupid...

I used the wrong Marlin folder which was not configured at all - which means the LCD was not configured at all which means...stupid mistake

anyway I used the correct files now at the world is right again
thanks all for the help. thank Fran@France