RAMPS Firmware for Hesine M-505

Hello Everyone,

I have had a Hesine M-505 printer from Aliexpress for a while now and it has printed fine. The other day the melzi board died. I have a RAMPS 1.4 board I want to replace it with. My question is, Is there a firmware that works for this printer for the RAMPS board. I have looked but with no luck.

Sincerely,

Keith

I don't know much about these printers but its a Prusa I3 type machine. So Marlin should work fine, you will need to ensure everything is connected properly, might have to crimp a few new plugs etc and configure the firmware but I don't see any major problems with converting it to ramps.

This thread seems to be relevant [forums.reprap.org]

Edited 1 time(s). Last edit at 05/01/2016 06:47PM by DjDemonD.

---

Simon Khoury

Co-founder of [www.precisionpiezo.co.uk] Accurate, repeatable, versatile Z-Probes
Published:Inventions