Welcome! Log In Create A New Profile


space between the layers

Posted by 3D rob 
space between the layers
June 18, 2016 03:21AM
Now when I print there is a little/a small space between the outermost layers.
(the inner layers fit well) in my opinion!

can that is because Marlin is not good? or the slic3r?
or is there perhaps a clogged nozzle?

which I myself think of:
I used to have a 0.3 nozzle, I have now(done in 0.4) been settled 0.4
I notified it only in slic3r
but I also had the extrusion length does not have to check to again?
but I had then maybe not also check the extrusion length again?
(I doubted which sentence was translated properly)

of course I will have to investigate it myself,
but if you have tips then please do!

How do I test it anyway?
without having to make a large print

sorry for bad translations!
Regards from the Netherlands

Edited 2 time(s). Last edit at 06/18/2016 04:50AM by 3D rob.
Re: space between the layers
June 18, 2016 03:06PM
I think I've found it!
my marlin stands on 80, 80, 4000, 800
in order to allow the extruder to extrude 100MM my Marlin now stands at 80, 80, 4000, 1450
I now had no space between the walls! thumbs up

Greetings all!

Edited 1 time(s). Last edit at 06/18/2016 03:06PM by 3D rob.
Re: space between the layers
June 19, 2016 02:24AM
Hoi Rob
You will experience gaps between layers when the part has 1mm thick walls and you try to print with a 0.4mm nozzle. The slicers don't know how to fill the 0.2mm gap.

Beste Groeten
Re: space between the layers
June 20, 2016 12:42PM
Hello Olaf,
HOOWWWwwww okay! (I understand!)

How can you solve this problem?
there is maybe a YouTube video where it will be discussed?
Sometimes I can understand a video better or faster.
but yes understand now how it happens,
glad you told it/me!

but here Also this,
my filament supply was much too little!
but there is a second (small) problem I understand now

happily as you can see it worked well enough (see the white?)

Friendly greetings from the Netherlands.

Edited 1 time(s). Last edit at 06/20/2016 12:47PM by 3D rob.
Sorry, only registered users may post in this forum.

Click here to login