Igus bearing with zip ties September 10, 2016 09:21AM |
Registered: 8 years ago Posts: 133 |
Re: Igus bearing with zip ties September 10, 2016 12:19PM |
Registered: 11 years ago Posts: 5,780 |
Re: Igus bearing with zip ties September 10, 2016 01:24PM |
Registered: 12 years ago Posts: 2,470 |
Re: Igus bearing with zip ties September 10, 2016 02:50PM |
Registered: 8 years ago Posts: 153 |
Quote
the_digital_dentist
Bearings/bushings on guide rails require precise fit to work properly. You can't adjust zip ties to provide precise fit. Zip ties are the duct tape of the 3D printing world. Use zip ties for their intended purpose- bundling wires. Use screws and bolts for precise mechanical attachments/adjustments.
Re: Igus bearing with zip ties September 10, 2016 03:35PM |
Registered: 11 years ago Posts: 5,780 |
Re: Igus bearing with zip ties September 10, 2016 06:52PM |
Registered: 10 years ago Posts: 564 |
Re: Igus bearing with zip ties September 13, 2016 11:25PM |
Registered: 8 years ago Posts: 153 |
Quote
the_digital_dentist
Before I knew better I designed this:
[www.thingiverse.com]
and this:
[www.thingiverse.com]
This is where I finished, before switching to linear guides:
[www.thingiverse.com]
The last one was far better than the other designs.
Re: Igus bearing with zip ties September 13, 2016 11:36PM |
Registered: 11 years ago Posts: 5,780 |