Marlin firmware, repetier host software, prusa I3.
In repetier exist 5 buttons that we can program to execute g codes. I have a few set to home all and auto level, but I like to keep my bed straight too. To facilitate this I wrote a gcode to allow me to focus just on the bed and not on moving things. The goal is to use G1 movement and G4 dwell commands to run me to a corner, wait 15 seconds, run me to a different corner wait 15 sec etc. So let's stay I'm starting at 0,0 I have g1 x0 y0 then g4 s10, etc. Only problem is when I run it, the extruder suffers loudly while it clicks it's way over to the corner slower than molasses. Everything works, during prints my moves across x and why are perfect. Any ideas?