Bottom layer thicker and Excess nozzle extrude at HOMING position
Posted by ManiPi
|
Re: Bottom layer thicker and Excess nozzle extrude at HOMING position October 20, 2016 01:56AM |
Have you looked at your Slicer settings check if you are printing with a raft.
I'll say it again too you need to turn your temps down and print at a slower speed for the first few layers to get good adhesion.
PLA doesn't need to be extruded at 205c plus for PLS I think you need to be printing with the fan on.
Give this a watch.
[www.youtube.com]
Out of the box thinking is easier when you never fitted in the box to begin with.
I'll say it again too you need to turn your temps down and print at a slower speed for the first few layers to get good adhesion.
PLA doesn't need to be extruded at 205c plus for PLS I think you need to be printing with the fan on.
Give this a watch.
[www.youtube.com]
Out of the box thinking is easier when you never fitted in the box to begin with.
|
Re: Bottom layer thicker and Excess nozzle extrude at HOMING position October 20, 2016 04:57AM |
Watch the YouTube Video I linked in my last message it will tell you how to set it up in Cura.
Out of the box thinking is easier when you never fitted in the box to begin with.
Out of the box thinking is easier when you never fitted in the box to begin with.
|
Re: Bottom layer thicker and Excess nozzle extrude at HOMING position October 20, 2016 05:51AM |
These are the PID settings for Marlin
[reprap.org]
Out of the box thinking is easier when you never fitted in the box to begin with.
[reprap.org]
Out of the box thinking is easier when you never fitted in the box to begin with.
Sorry, only registered users may post in this forum.