Hangprinter version 2
Posted by tobben
|
Re: Hangprinter version 2 November 10, 2017 03:39PM |
Where did you read it?|
Re: Hangprinter version 2 November 11, 2017 10:17PM |
Sorry if I spoiled the surprise
Tom is the man. Let him know I have been working hard. Ha ha ha. I ask him questions often on his live streams. Good luck guys!
Tom is the man. Let him know I have been working hard. Ha ha ha. I ask him questions often on his live streams. Good luck guys!
|
Re: Hangprinter version 2 November 12, 2017 04:55AM |
|
Re: Hangprinter version 2 December 15, 2017 11:39PM |
Well, I am sad to say, but it's time to let the v2 go. After many hours of testing, I have seen the light during Tom's live streams and have to move on to v3. It's too cool to pass up. Goodbye v2. 
Thanks Torbjorn and Tom, the live streams are awesome.
Tom's first hang live stream
Edited 1 time(s). Last edit at 12/16/2017 10:22AM by brotherchris.
Thanks Torbjorn and Tom, the live streams are awesome.
Tom's first hang live stream
Edited 1 time(s). Last edit at 12/16/2017 10:22AM by brotherchris.
|
Re: Hangprinter version 2 December 16, 2017 09:19AM |
Cool, I'm glad you liked it
You will prooobably be first to be able to compare the v2 and v3 builds first hand. I'm looking forward to that!
torbjornludvigsen.com
You will prooobably be first to be able to compare the v2 and v3 builds first hand. I'm looking forward to that!
torbjornludvigsen.com
Sorry, only registered users may post in this forum.