Re: Cloned titan extruder review/opinion... September 05, 2018 05:00PM |
Registered: 5 years ago Posts: 61 |
Re: Cloned titan extruder review/opinion... September 06, 2018 05:00AM |
Registered: 6 years ago Posts: 1,007 |
Quote
mcdanlj
It's the one I asked DD about on August 12 earlier in this thread.
If I wait to see if there is a problem before milling out for a second bearing on the front, I'll lose the ability to use a center finder to index the mill to the hole, and if I end up with bearings that don't align I'll really mess them up. On the other hand, the lever arm might be sufficiently constrained that there's no need for a second bearing. On the other other hand, I already bought a 10-pack of MR58 bearings, so maybe I really should use at least one of them. On the other other other hand, I have now replacements if any of the several included MR58 bearings fail, even if I don't modify the arm.
Re: Cloned titan extruder review/opinion... September 09, 2018 04:08PM |
Registered: 5 years ago Posts: 61 |