Can any slicer vary layer height? April 23, 2017 01:35PM |
Registered: 7 years ago Posts: 270 |
Re: Can any slicer vary layer height? April 23, 2017 05:47PM |
Registered: 8 years ago Posts: 267 |
Re: Can any slicer vary layer height? April 24, 2017 02:39AM |
Registered: 9 years ago Posts: 5,232 |
Quote
This setting can be temperamental and only likes to work when you have a small layer height, anything over 0.2 and it dose not like to work.
Re: Can any slicer vary layer height? April 24, 2017 04:59AM |
Registered: 9 years ago Posts: 601 |
Re: Can any slicer vary layer height? April 24, 2017 09:02AM |
Registered: 12 years ago Posts: 153 |
Re: Can any slicer vary layer height? April 24, 2017 01:06PM |
Registered: 7 years ago Posts: 103 |
Quote
scottybfg
Yes,
Slic3r has what they call microlayering, it combines infill every "nth" layer. So you could have your layer height set to 0.1mm then set microlayering to 2 layers to get infill at 0.2mm. This setting can be temperamental and only likes to work when you have a small layer height, anything over 0.2 and it dose not like to work.
Re: Can any slicer vary layer height? April 24, 2017 03:48PM |
Registered: 9 years ago Posts: 601 |
Re: Can any slicer vary layer height? April 24, 2017 10:30PM |
Registered: 8 years ago Posts: 267 |
Quote
o_lampe
That's not entirely true, because it depends on nozzle size too. With a Volcano hotend and 0.8mm nozzle I could print 0.2 walls and 0.6 infill