3GT Belts and Pulleys May 11, 2017 08:35AM |
Registered: 7 years ago Posts: 34 |
Re: 3GT Belts and Pulleys May 11, 2017 11:44AM |
Registered: 10 years ago Posts: 564 |
Re: 3GT Belts and Pulleys May 11, 2017 12:23PM |
Registered: 7 years ago Posts: 270 |
Re: 3GT Belts and Pulleys May 11, 2017 07:55PM |
Registered: 7 years ago Posts: 34 |
Re: 3GT Belts and Pulleys May 11, 2017 08:25PM |
Registered: 10 years ago Posts: 564 |
Re: 3GT Belts and Pulleys May 12, 2017 06:00AM |
Registered: 8 years ago Posts: 5,232 |
Re: 3GT Belts and Pulleys May 12, 2017 12:58PM |
Registered: 7 years ago Posts: 34 |
Re: 3GT Belts and Pulleys May 12, 2017 10:00PM |
Registered: 9 years ago Posts: 483 |
Re: 3GT Belts and Pulleys May 12, 2017 10:25PM |
Registered: 7 years ago Posts: 34 |
Quote
etfrench
Why? They are more than adequate for the loads a printer will be putting on them.Quote
shortyski13
Quote
o_lampe
Here is a good place to look for GT3 pulleys. They're called GT2-3mm as mentioned above.
Trying to avoid plastic bearings. Much appreciated though.
Re: 3GT Belts and Pulleys May 13, 2017 02:27PM |
Registered: 9 years ago Posts: 483 |
Quote
shortyski13
Quote
etfrench
Why? They are more than adequate for the loads a printer will be putting on them.Quote
shortyski13
Quote
o_lampe
Here is a good place to look for GT3 pulleys. They're called GT2-3mm as mentioned above.
Trying to avoid plastic bearings. Much appreciated though.
I thought they would wear out very quickly and wouldn't be very precise. I could be wrong. Plus they aren't shiny ;-)
Re: 3GT Belts and Pulleys May 17, 2017 03:09PM |
Registered: 7 years ago Posts: 34 |
Re: 3GT Belts and Pulleys May 18, 2017 03:22AM |
Registered: 9 years ago Posts: 483 |