About to buy Anet A8 May 20, 2017 05:01PM |
Registered: 6 years ago Posts: 12 |
Re: About to buy Anet A8 May 20, 2017 05:59PM |
Registered: 7 years ago Posts: 41 |
Re: About to buy Anet A8 May 20, 2017 07:32PM |
Registered: 6 years ago Posts: 12 |
Quote
Pheneeny
I would recommend PLA filament for your first prints, I find it the easiest to print, it prints at a low temperature and isn't fussy. The Anet A8 comes with an old version of Cura for slicing, but you can use the newest version just fine. I would recommend installing Skynet3D firmware and enabling the thermal protections. These are disabled in the default firmware.
Re: About to buy Anet A8 May 21, 2017 01:14PM |
Registered: 7 years ago Posts: 41 |
Re: About to buy Anet A8 May 22, 2017 01:26PM |
Registered: 6 years ago Posts: 8 |
Re: About to buy Anet A8 May 22, 2017 02:29PM |
Registered: 6 years ago Posts: 12 |
Re: About to buy Anet A8 May 22, 2017 02:32PM |
Registered: 6 years ago Posts: 12 |