Welcome! Log In Create A New Profile

Advanced

Problems with the first layers confused smiley

Posted by DE_BA_17 
Forum List Message List New Topic
DE_BA_17
Problems with the first layers confused smiley
July 04, 2017 11:51AM
Hello everybody spinning smiley sticking its tongue out,

For my final examination, I would like to analyze the PETG filament.I print Single-walled components(0.5 mm) with the Slic3r. In the pictures you see the first 3 layer and the settings.

In the second layer is a problem when the speed is increased.

Has anyone experience with single-walled components? Does anyone have tips for settings?

Thanks for you help in my current situation.
tongue sticking out smiley
Reply Quote
Attachments:
open | download - first layer.jpg (74.5 KB)
open | download - second layer.jpg (85.8 KB)
open | download - third layer.jpg (93.6 KB)
open | download - speed settings.jpg (65.8 KB)
open | download - temperature settings.jpg (43.6 KB)
newbob
Re: Problems with the first layers confused smiley
July 05, 2017 12:47PM
PETG recommended temperature is between 240 and 260.
Reply Quote
Bill Clark
Re: Problems with the first layers confused smiley
July 05, 2017 05:34PM
nozzle too high
Reply Quote
obewan
Re: Problems with the first layers confused smiley
July 06, 2017 05:20AM
1st layer too fast, try setting it at 15mm/s
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login