Won't print after Cura change

REVISION

Sorry to have to admit that I have found the problem.

It was a loose connector.



I have a Monoprice Maker Select (Wanhao).

Tried to upgrade to Cura 2.6 and could not get it to work so I went back to Cura 15.4.

Now the printer only prints in a very narrow strip along the plates left side (x+0).

Any ideas?

Thanks

Edited 1 time(s). Last edit at 08/10/2017 06:32PM by ntar827.

I no idea but you selected the right gcode flavour in machine setting

Jinx

Thanks for your response bu I found the problem.

Embarrassed to admit that it was a loose cable.