Detailed questions regarding gcode (federate, acceleration, jerk) September 18, 2017 12:31PM |
Registered: 11 years ago Posts: 18 |
M204S3000 M205X20 G1F1800X20.222Y18.834E0.01486 G1X20.87Y18.383E0.02971 G1X21.561Y17.999E0.04458 G1X22.286Y17.687E0.05943 ....
Re: Detailed questions regarding gcode (federate, acceleration, jerk) September 18, 2017 07:32PM |
Admin Registered: 13 years ago Posts: 7,001 |
Re: Detailed questions regarding gcode (federate, acceleration, jerk) September 19, 2017 10:19AM |
Registered: 11 years ago Posts: 335 |
Quote
In the wiki the S refers to 'normal moves' and a T to filament only moves. What are filament only moves?
Quote
Is the max value used for all moves??
Quote
Is the jerk actually the third derivative of the position value or is it a sort of minimum acceleration?
Quote
In line 3 the federate is set to 1800 mm/ for all following commands or just for the G1 command in line 3?
Re: Detailed questions regarding gcode (federate, acceleration, jerk) September 19, 2017 03:14PM |
Registered: 11 years ago Posts: 18 |
Quote
Dust
Feed rates set the axis speed, when moving multiple axis in one command the lowest feed rate is used (normally E axis)
Re: Detailed questions regarding gcode (federate, acceleration, jerk) September 19, 2017 05:20PM |
Registered: 8 years ago Posts: 3,525 |
Re: Detailed questions regarding gcode (federate, acceleration, jerk) September 19, 2017 06:11PM |
Registered: 11 years ago Posts: 335 |
G1 X10Y10 E1 F500 G1 X10Y10 E10 F500
Quote
G1 X10 Y10 E0.56 F5000
[reprap.org]Quote
Xnnn The position to move to on the X axis
Ynnn The position to move to on the Y axis
Znnn The position to move to on the Z axis
Ennn The amount to extrude between the starting point and ending point
Fnnn The feedrate per minute of the move between the starting point and ending point (if supplied)
Re: Detailed questions regarding gcode (federate, acceleration, jerk) September 19, 2017 07:19PM |
Registered: 8 years ago Posts: 3,525 |