step motor over drive January 17, 2018 01:05PM |
Registered: 9 years ago Posts: 133 |
Re: step motor over drive January 17, 2018 01:30PM |
Registered: 7 years ago Posts: 363 |
Re: step motor over drive January 17, 2018 04:20PM |
Registered: 9 years ago Posts: 133 |
Quote
obelisk79
Sounds like a calibration issue.
If I had to guess, you either have not properly set your nozzle height in relation to the print surface or your extruder steps are set too high in your printer configuration.
Edit: Is this a new problem, or have you always had this issue with your i3?