How to replace A4988 Driver with TB6600 Stepper Motor Driver in Rumba motherboard

Dear respected friends, Hope all are in good health with success and happiness.
I am making a big 3D printer using Rumba motherboard where I am using Nema 23 stepper motor which need 3 Amps. But, A4988 Driver can provide max 2 Amps current. That's why I am using TB6600 stepper motor driver.

Therefore, I have to replace A4988 stepper driver pins with TB6600 stepper driver in RUMBA but I am facing some problem. Here I have added a picture where used RAMPS 1.4 board. Just I need same wire diagram for RUMBA control board. I need your help ..........

Edited 3 time(s). Last edit at 03/16/2018 01:32PM by mubarak111nsu.

The driver sockets for Rumba and RAMPS are identical, just differently positioned. You can use the exact same pins.
Something like this makes it even simpler
[www.google.de]:

---

[www.bonkers.de]
[merlin-hotend.de]
[www.hackerspace-ffm.de]

Why not use a Duet instead of a Rumba? A Duet Wifi or Duet Ethernet can drive Nema 23 motors directly without external drivers, up to 2.4A - which is as high as you probably want to run a 3A motor anyway, to avoid cooking it.

Edited 1 time(s). Last edit at 03/16/2018 03:02PM by dc42.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Dear respected friend, I am really grateful to your for your reply.

Here I have attached a file where I gonna use TB6600 driver. Please could you help me to make a similar kind of wire diagram using RUMBA control board?

I am using RUMBA control board as I amusing 3 in 1 out extruder. RUMBA allow to use 3 extruder and that's why I am using RUMBA.

Edited 1 time(s). Last edit at 03/16/2018 07:18PM by mubarak111nsu.