Welcome! Log In Create A New Profile


BevelCNC V1

Posted by Trakyan 
BevelCNC V1
May 30, 2018 10:31PM
So I finally got a successful print off my printer, turns out I needed some abs juice to get things to stop warping up no matter how hot I got the bed or chamber.

I'm starting this thread as a sort of build log. Feel free to comment/critisize/make suggestions about the design and project.

Before I start printing the final parts (been fine tuning the tolerances so far), are there any opinions/preferences on whether the official design should use 25.4 or 31.8 mm tubing? Still on the fence. It seems like a material usage vs rigidity question, but I'm not sure the tubes are the weakest link to begin with.
Sorry, only registered users may post in this forum.

Click here to login