Marlin firmware with folger2020?

I'm trying to enable bed autoleveling on my folger2020. To that end, I would like to flash my folger2020 with original Marlin firmware.

Has anyone done this? Is there anything to change from stock Marlin besides what you do for a normal printer anyway? ie, thermistor, steps, etc.

Basically anything needed outside Configuration.h or Configuration_adv.h ?

(Another reason for using stock Marlin with folger2020 is the provided folger2020 firmware doesn't compile....but that's an aside)

How about posting in the correct section ?

---

"A comical prototype doesn't mean a dumb idea is possible" (Thunderf00t)

Sorry just trying to get more visibility on this.

My printer clogs on every single print and it's been doing it for months.

I have to relevel the bed every single time I unclog the nozzle.

Please imagine how frustrating this is.

The various causes for clogging have been discussed here over and over. Do a search.
Otherwise you will just add the firmware upgrade, auto bed leveling issues ....

---

"A comical prototype doesn't mean a dumb idea is possible" (Thunderf00t)

To answer my original question, for anyone that is reading this: the answer is yes, you can use stock Marlin firmware with the Folger2020, you basically just have to gather the calibration data from the stock folger firmware and move it over to the Marlin firmware.