Anet A8M

I would like to ask if someone could tell me what motherboard I have on my new Anet printer.I would like to update to new Marlin.

Can you make the picture smaller? I can see way to much detail on that thumbnail

Its a custom job.... no doumentation

It looks like the large black chip says atmel, so there is hope that regular marlin may run on it, but I cant read the numbers.
But as for what board it may be compatible with? is unknown.

I would try a ramps and see what doesnt work... (with hotend and heated bed unplugged for safety)

but find out what the numbers on that large black chip say first.

Edited 1 time(s). Last edit at 08/05/2018 11:01AM by Dust.

Looks a lot like my MKS GEN_L, though the ESP and endstop pin locations are switched.

Still, the ESP1 and ESP2 headers to connect to the RepRap discount controller are probably a very good indication that it's a Mega2560/RAMPS1.4 clone board. Take a look at the big chip on the board for "MEGA2560" in the print, and you can probably be assured that this is indeed what it is.

---

MBot3D Printer
MakerBot clone Kit from Amazon
Added heated bed.

Leadscrew self-built printer (in progress)
Duet Wifi, Precision Piezo parts

Have any luck with this? I have the same board and am looking at updating the firmware.

That’s a KFB 2.0 board.

Here’s an helpful instructable Link on the board.